Question 520
At a campus network built with Juniper EX switches, a Junos specialist investigates this scenario: Two VLANs need different active Layer 2 paths but use one common spanning-tree root everywhere. The intended segmentation and loop prevention must remain intact. What requirement most specifically calls for this approach?
Explanation
Correct Answer
For a campus network built with Juniper EX switches, this mechanism fits the requirement: Use VSTP when different VLANs require distinct Layer 2 forwarding trees. The design is appropriate because: VLAN Spanning Tree Protocol allows separate tree instances for selected VLANs and can choose different roots. In this scenario, the observed issue is: Two VLANs need different active Layer 2 paths but use one common spanning-tree root everywhere. The corresponding implementation is: Configure supported VSTP membership and root priorities for the chosen VLANs.
Incorrect Answers
A link aggregation group presents multiple member links as one logical Ethernet interface when both peers agree. The appropriate correction for the reported case is: Configure supported VSTP membership and root priorities for the chosen VLANs.
An untagged Ethernet access port places endpoint traffic into its configured access VLAN. Fixing that different mechanism would not address the current root cause: VLAN Spanning Tree Protocol allows separate tree instances for selected VLANs and can choose different roots.
MSTP region boundaries interact with neighboring spanning-tree variants through common spanning-tree behavior. Its verification is distinct from the reported condition: Two VLANs need different active Layer 2 paths but use one common spanning-tree root everywhere. The intended segmentation and loop prevention must remain intact.