Question 190
In the fictional Atlas-7 east pod, a service recovery task following a partial path outage, the team reports that multiple tenant subnets must communicate but unrelated tenants must remain isolated. An unrelated configuration change is being considered. Which focused remediation best addresses the described problem first?
Explanation
Correct Answer
Tenant-specific L3 EVPN separates inter-subnet routing from cross-customer leakage. The option uses “Use tenant-specific IP-VRF routing with the intended L3 EVPN overlay service” to address “multiple tenant subnets must communicate but unrelated tenants must remain isolated”. The result must be observed on the affected component. Recovery acceptance must verify service state after the fault, not merely a configuration entry.
Incorrect Answers
“Replace EVPN routing with logging-only policies” targets a different operation from the reported requirement: “multiple tenant subnets must communicate but unrelated tenants must remain isolated”. Tenant-specific L3 EVPN separates inter-subnet routing from cross-customer leakage. Use the appropriate method: Use tenant-specific IP-VRF routing with the intended L3 EVPN overlay service. Recovery acceptance must verify service state after the fault, not merely a configuration entry.
“Bridge all tenants into the same MAC-VRF to make routes unnecessary” targets a different operation from the reported requirement: “multiple tenant subnets must communicate but unrelated tenants must remain isolated”. Tenant-specific L3 EVPN separates inter-subnet routing from cross-customer leakage. Use the appropriate method: Use tenant-specific IP-VRF routing with the intended L3 EVPN overlay service. Recovery acceptance must verify service state after the fault, not merely a configuration entry.
“Share a single unrestricted default route table among customers” targets a different operation from the reported requirement: “multiple tenant subnets must communicate but unrelated tenants must remain isolated”. Tenant-specific L3 EVPN separates inter-subnet routing from cross-customer leakage. Use the appropriate method: Use tenant-specific IP-VRF routing with the intended L3 EVPN overlay service. Recovery acceptance must verify service state after the fault, not merely a configuration entry.