Question 440
At a multihomed data center using redundant Ethernet segments, a Junos specialist investigates this scenario: A multihomed VXLAN service receives duplicate flooded frames from two attached PEs. The design must avoid forwarding loops during failover. When would the described mechanism be appropriate?
Explanation
Correct Answer
For a multihomed data center using redundant Ethernet segments, this mechanism fits the requirement: Use EVPN DF election to control redundant BUM forwarding on multihomed segments. The design is appropriate because: EVPN DF election coordinates BUM forwarding responsibilities for applicable multihomed Ethernet segments. In this scenario, the observed issue is: A multihomed VXLAN service receives duplicate flooded frames from two attached PEs. The corresponding implementation is: Verify the designated-forwarder election and associated multihoming mode for the affected VLAN or Ethernet tag.
Incorrect Answers
EVPN uses a BGP signaling address family to distribute Ethernet reachability and related control-plane information. The appropriate correction for the reported case is: Verify the designated-forwarder election and associated multihoming mode for the affected VLAN or Ethernet tag.
EVPN single-active multihoming restricts the forwarding role on an Ethernet segment to a selected active PE. Fixing that different mechanism would not address the current root cause: EVPN DF election coordinates BUM forwarding responsibilities for applicable multihomed Ethernet segments.
VXLAN tunnels require IP reachability between VTEP addresses and adequate underlay transport capacity. Its verification is distinct from the reported condition: A multihomed VXLAN service receives duplicate flooded frames from two attached PEs. The design must avoid forwarding loops during failover. When would the described mechanism be appropriate.