Question 390
At an enterprise migrating virtual machines between racks, a Junos specialist investigates this scenario: A tenant requires only one active forwarding attachment at a time but both dual-homed PEs transmit simultaneously. The overlay must relearn host reachability without stale tunnel selection. For which use case is this feature the best match?
Explanation
Correct Answer
For an enterprise migrating virtual machines between racks, this mechanism fits the requirement: Use single-active EVPN multihoming when only one attached PE should forward at a time. The design is appropriate because: EVPN single-active multihoming restricts the forwarding role on an Ethernet segment to a selected active PE. In this scenario, the observed issue is: A tenant requires only one active forwarding attachment at a time but both dual-homed PEs transmit simultaneously. The corresponding implementation is: Select a supported single-active multihoming design and check ESI and DF behavior.
Incorrect Answers
EVPN Ethernet Auto-Discovery route type 1 participates in multihoming reachability and mass-withdraw behavior. The appropriate correction for the reported case is: Select a supported single-active multihoming design and check ESI and DF behavior.
EVPN Ethernet Segment route type 4 supports discovery of PEs connected to the same Ethernet segment. Fixing that different mechanism would not address the current root cause: EVPN single-active multihoming restricts the forwarding role on an Ethernet segment to a selected active PE.
EVPN all-active multihoming permits multiple PEs to forward eligible known-unicast traffic with appropriate control-plane loop prevention. Its verification is distinct from the reported condition: A tenant requires only one active forwarding attachment at a time but both dual-homed PEs transmit simultaneously. The overlay must relearn host reachability without stale tunnel selection.