Question 730
One branch reaches a PE over IP but fails when the same traffic is forwarded across the MPLS core. What implementation step and validation result should be selected?
Explanation
Correct Answer
Because successful ordinary IP forwarding does not isolate MPLS packet forwarding faults, the best response is to compare ingress label imposition with transit LFIB and egress disposition. A reviewer can close the technical case only after confirming that a hop-by-hop labeled test locates and corrects the failing label action.
Incorrect Answers
The proposed principle concerns another network fault: A labeled transport next hop must be available to carry the overlay service. Here, successful ordinary IP forwarding does not isolate MPLS packet forwarding faults. The most direct correction is to compare ingress label imposition with transit LFIB and egress disposition, confirmed by a hop-by-hop labeled test locates and corrects the failing label action.
That result would be useful for a different failure, namely: A route reflector advertises routes to the wrong clients after a change in group membership. The current case specifically calls for: Compare ingress label imposition with transit LFIB and egress disposition. The required observed result is: A hop-by-hop labeled test locates and corrects the failing label action.
This response would target a different source scenario: A loopback loses its MPLS-resolvable route but ordinary IP routing to the loopback remains reachable. It cannot establish the current acceptance requirement, which is: A hop-by-hop labeled test locates and corrects the failing label action. The relevant action is: Compare ingress label imposition with transit LFIB and egress disposition.