Question 60
IPv4 IS-IS routing works but IPv6 routes do not appear on a dual-stack backbone. Which post-change observation most strongly confirms the correction?
Explanation
Correct Answer
This is the model-intended best choice because iS-IS can convey multiple address families with appropriate support. The targeted correction is to check the IPv6 family configuration and advertised reachability rather than rebuilding IPv4 adjacency. Validate it by observing that both address families display their expected prefixes through the same stable topology.
Incorrect Answers
That result would be useful for a different failure, namely: An IS-IS route disappears after a policy update while the LSP database still contains the topology. The current case specifically calls for: Check the IPv6 family configuration and advertised reachability rather than rebuilding IPv4 adjacency. The required observed result is: Both address families display their expected prefixes through the same stable topology.
This response would target a different source scenario: An IS-IS neighbor appears only at Level 2 even though the design expects a Level 1 core segment. It cannot establish the current acceptance requirement, which is: Both address families display their expected prefixes through the same stable topology. The relevant action is: Check the IPv6 family configuration and advertised reachability rather than rebuilding IPv4 adjacency.
The alternative addresses a router learns the same prefix from peers in distinct autonomous systems but the engineer compares only BGP hop count, not the present root cause. Here the selected correction must reflect iS-IS can convey multiple address families with appropriate support. Test for: Both address families display their expected prefixes through the same stable topology.