Question 390
A design review identifies: A team deploys four ZTNA Connectors across one group and assumes adding a fifth will automatically increase per-group capacity. The team has confirmed: Review published connector group limits, load balancing and subscription entitlements. What design action addresses the confirmed issue?
Explanation
Correct Answer
The appropriate architecture decision is to design additional connector groups and validate application assignment when scale exceeds group support. The stated requirement is: A team deploys four ZTNA Connectors across one group and assumes adding a fifth will automatically increase per-group capacity. It follows from the evidence gathered by review published connector group limits, load balancing and subscription entitlements, and should be signed off only after load testing stays within supported per-group capacity and application mappings.
Incorrect Answers
The distinct use case for this response is “A private app uses unsupported NAT-sensitive IP semantics and a planned ZTNA Connector SNATs traffic”. The prior inspection is test whether the application requires original client addresses or rejects address translation. The present case instead calls for “Design additional connector groups and validate application assignment when scale exceeds group support”.
This would be appropriate for “an architect wants a global colocation interconnect but assumes a private on-ramp and off-ramp are interchangeable”. The prior inspection is identify whether traffic is entering Prisma Access or returning to private application networks. Here the decisive requirement is “Design additional connector groups and validate application assignment when scale exceeds group support”.
The alternative deals with “an application backend needs to initiate a connection to a managed endpoint, but the team proposes a connector design without validating directionality”. Under change control, verify that authorized management connections work in the required direction without opening general inbound access rather than relying on a diagram alone. The current question instead selects “Design additional connector groups and validate application assignment when scale exceeds group support”.