Question 530
A deployment engineer must resolve the following case: A team configures passive SLA monitoring on a member carrying almost no application traffic and expects uninterrupted measurement. What is the most appropriate supported action?
Explanation
Correct Answer
The change needed here is: Use an appropriate supported active or passive strategy and verify the sample data source. Relevant Fortinet behavior: Passive measurement depends on relevant observed traffic and may lack samples when idle. Acceptance evidence should show: SLA status has useful measurements during idle and active application periods.
Incorrect Answers
This option serves the scenario “Operators see SLA packet loss for one carrier but FortiManager's dashboard only shows an aggregate green status”. The change needed here is: Inspect FortiManager member and SLA health details and correlate to measured probes. The present scenario is distinguished by “Use an appropriate supported active or passive strategy and verify the sample data source”.
This would treat symptoms while leaving the actual constraint in place. The relevant technical distinction is: Passive measurement depends on relevant observed traffic and may lack samples when idle. Verify the controlled fix through: SLA status has useful measurements during idle and active application periods.
This alternative does not match the described failure pattern. It concerns an SD-WAN rule stops sending traffic to an alternate member after that member recovers from a short fault; the focused result here is: Use an appropriate supported active or passive strategy and verify the sample data source.