Question 430
An architect analyzes this issue: A site uses only passive measurements for an infrequently used emergency application that must remain ready. Which operational or security exposure is most important to avoid?
Explanation
Correct Answer
That risk should be controlled as part of the approved change. The reason is: Critical standby services need meaningful path readiness signals even before first user traffic. The safer action is: Add a supported active readiness measurement with an appropriate target for the standby path. Validation: A failed standby link is detected before the emergency application is needed.
Incorrect Answers
This alternative addresses the separate case “A performance SLA probe reaches the router hop but a critical business application behind it is unavailable”. The failure exposure comes from the underlying condition: L3 reachability of an intermediate hop is not equivalent to end-to-end service performance. The deciding requirement here is “An idle standby can appear healthy until the first emergency request fails”.
The option would apply to “A voice application is routed over the lowest-cost WAN member even when measured jitter exceeds the service target”. The operational danger arises from this condition: Cost alone is insufficient when a traffic class has explicit latency and jitter constraints. This question instead requires “An idle standby can appear healthy until the first emergency request fails”.
The related but distinct situation is “Two uplinks appear healthy but a configured performance SLA threshold is stricter than the measured application can reasonably achieve”. The named risk is directly connected to the design rule: Unrealistic SLA targets make all eligible paths appear degraded. For the stated problem, “An idle standby can appear healthy until the first emergency request fails” addresses the central condition.