Question 630
A security change aims to correct: The SD-WAN monitor reports a dead health-check target but provider interface counters and independent external access are normal. The chosen fix is repair or replace the defective monitoring destination before declaring the provider circuit unavailable. Which observed test result directly supports closing this change?
Explanation
Correct Answer
Acceptance requires evidence that a validated monitoring target responds and accurately distinguishes the working circuits. The original problem was: The SD-WAN monitor reports a dead health-check target but provider interface counters and independent external access are normal. The team applied the remedy to repair or replace the defective monitoring destination before declaring the provider circuit unavailable. This outcome checks the actual security or connectivity effect, including the intended scope, rather than only proving that the candidate configuration saved or that a push job reported completion.
Incorrect Answers
The target site's failure test behaves as intended and unrelated sites retain their former decisions. That alternative is checked by confirming that scope the SLA change to authorized devices or creating a separate profile for the test branch; the actual requirement instead calls for confirming that a validated monitoring target responds and accurately distinguishes the working circuits.
The private overlay probe returns successfully and fails accurately if the protected path is taken down. repairing the intended private probe route or tunnel reachability and retaining overlay-specific measurement tests that mechanism, but it does not establish the reported condition—the SD-WAN monitor reports a dead health-check target but provider interface counters and independent external access are normal.
Each displayed value corresponds to the right physical circuit and traffic chooses the correct candidate. Its technical evidence involves confirming that rebind the health monitor to the actual member IDs and confirming fresh measurement updates. For the stated question, confirming that a validated monitoring target responds and accurately distinguishes the working circuits is the more relevant test.