Question 280
After the change "Register only valid usable member interfaces and apply suitable routes and security policies", operators must validate the original complaint: A new FortiGate joins an existing network, and an engineer assumes any software interface can be used for SD-WAN without checking its status. Which outcome is the strongest acceptance evidence?
Explanation
Correct Answer
Acceptance requires evidence that the resulting SD-WAN configuration has operable members with real link status and passing test traffic. The original problem was: A new FortiGate joins an existing network, and an engineer assumes any software interface can be used for SD-WAN without checking its status. The team applied the remedy to register only valid usable member interfaces and apply suitable routes and security policies. This outcome checks the actual security or connectivity effect, including the intended scope, rather than only proving that the candidate configuration saved or that a push job reported completion.
Incorrect Answers
Authorized applications pass and a controlled blocked category is still inspected on either WAN link. That alternative is checked by confirming that preserve the required policy inspection settings while adjusting only path steering and zone matching; the actual requirement instead calls for confirming that the resulting SD-WAN configuration has operable members with real link status and passing test traffic.
The corrected member successfully forwards probes and new sessions through the replacement router. replacing the retired next-hop with the approved reachable upstream gateway and retest the link tests that mechanism, but it does not establish the reported condition—a new FortiGate joins an existing network, and an engineer assumes any software interface can be used for SD-WAN without checking its status.
New outbound sessions match the approved security rule and use permitted member links. Its technical evidence involves updating the authorized internet policy to reference the correct SD-WAN zone and keeping inspection profiles attached. For the stated question, confirming that the resulting SD-WAN configuration has operable members with real link status and passing test traffic is the more relevant test.